Do I Need a Structural Engineer or Will a General Home Inspector Work?
A general home inspector is enough for a broad, visual check of the whole house, but you need a structural engineer when there's a specific structural concern, such as a foundation crack, a bowing basement wall, a sagging floor, or a plan to remove a load-bearing wall. It comes down to whether you need an overview or a diagnosis. Home inspectors note visible defects, and when something looks wrong, their reports often say "recommend further evaluation by a structural engineer." A licensed professional engineer can explain what caused the problem, judge how serious it is, and design a repair or size a new beam. Engineers can also provide sealed reports, which lenders and building departments may ask for.
What Is the Difference Between a Structural Engineer and a Home Inspector?
A home inspector gives a wide, visual look at the whole house, while a structural engineer is a licensed professional who studies how the building carries weight and why something is failing.
In one visit, a home inspector looks at the roof, plumbing, electrical, heating and cooling, windows, and the parts of the structure they can see, then writes up a general condition report on the house. A structural engineer looks only at the frame, foundation, beams, joists, and walls. You get back a diagnosis and, if the house needs one, a repair design.
Licensing differs, too. In Missouri, engineers must be licensed as Professional Engineers (PE) through the state board. Missouri has no statewide license for home inspectors, so training varies from one inspector to the next.
A home inspector can't seal (stamp) a report or drawing. A licensed PE can. The seal is the engineer's official mark showing a licensed PE takes responsibility for the work, and building departments or lenders may ask for one.
| Home Inspector | Structural Engineer | |
|---|---|---|
| Scope | Whole house: roof, systems, visible structure | Foundation, framing, beams, joists, walls |
| License in Missouri | No statewide license | Licensed Professional Engineer (PE) |
| Depth | Visual, surface-level review | Cause, severity, and load path analysis |
| Tools | Flashlight, moisture meter, visual checks | Levels, measurements, load calculations |
| What you get | General condition report | Diagnosis, recommendations, sealed letter or drawings |
| When to hire | Buying a house, general checkup | Red flags, "further evaluation" notes, wall or beam changes |
What Does a General Home Inspector Check and Not Check?
A home inspector checks the parts of the house they can see and reach, but they don't measure loads, calculate beam sizes, or decide if a structure is safe.
During a typical inspection, the inspector looks for these visible items:
- Foundation walls they can see from the basement or crawlspace
- Cracks in walls, floors, and masonry
- Water stains and signs of moisture
- Sloping floors
- Doors and windows that stick
- Attic framing
Some things fall outside the job. Inspectors generally don't move furniture or stored boxes, open walls, test soil, run load math, or give you a repair design. The ASHI home inspection Standard of Practice states that inspectors aren't required to determine the adequacy of a system or component, and structural adequacy is exactly the question an engineer answers.
When an inspector sees something off, the report usually says "monitor" or "further evaluation recommended by a qualified structural engineer." Read that line as a handoff. The inspector has found a possible problem and is telling you who can explain it.
Why home inspection reports say 'further evaluation recommended'
Home inspectors are generalists. When they see a concern outside their scope, they flag it so they don't have to guess at a cause or a fix. Skip that note, and you could close on a house with a problem nobody has measured or explained. Book a structural engineer soon after you see that line, while you still have time inside your inspection deadline.
When Do You Need a Structural Engineer Instead of a Home Inspector?
You need a structural engineer when you see signs that the house is moving or carrying weight poorly, or when you plan to change how the house carries weight.
Some of these are red flags you can see today; others are projects you haven't started yet. Both call for an engineer, because both are about the load path, the route weight travels from the roof down through walls, beams, and the foundation into the soil.
Here are seven common triggers:
- Horizontal cracks in a basement wall
- Stair-step cracks in block or brick
- Basement walls that bow inward or lean
- Wide cracks, or cracks that keep growing
- Floors that sag or feel bouncy
- Doors and windows that suddenly start to stick
- Plans to remove or cut a wall, beam, or joist
A growing crack or a bowing wall should get looked at soon. Waiting gives the problem time to spread, and a small repair can turn into a bigger one.
Commercial property follows the same logic, with even less room for a home inspector. Tenant buildouts, mezzanines, additions, and building purchases often call for a structural engineer.
Signs of foundation or framing trouble
Thin vertical hairline cracks in poured concrete are often shrinkage from when the concrete cured. Horizontal cracks and bowing usually point to soil pressing on the wall from outside. Sagging floors can come from joists that were too small to begin with, rot, or a beam someone cut during an old remodel. One sign on its own may mean little. Several at once (a stair-step crack, a sticking door above it, and a sloped floor nearby) tell a stronger story and deserve a closer look.
Planning to remove a wall or remodel
Before a wall comes down, a structural engineer confirms whether the wall is load-bearing. If it carries weight, the engineer sizes the beam that replaces it (often an LVL, or laminated veneer lumber, a strong engineered wood beam) and the posts that hold that beam up. Building departments often ask for sealed structural drawings before they issue a permit for beam changes. A home inspector can't provide beam sizing or permit drawings.
Can a Home Inspector Tell If a Foundation Crack Is Serious?
A home inspector can spot and describe a foundation crack, but an inspector can't reliably tell you its cause or how serious it is. That's an engineer's job.
A structural engineer reads several clues at once: crack direction, width, and pattern, signs that the wall itself has moved, how water drains around the house, and the type of soil under it. Read side by side, those clues point to a cause.
Two cracks can look almost the same and still have very different causes and fixes. One might be old shrinkage that only needs sealing. Another might come from soil pressure, and that wall needs bracing.
Guessing goes wrong in both directions. Treat a minor crack as major, and you may pay for repairs you didn't need. Treat a major crack as minor, and the problem can get worse and cost more to fix later.
A simple habit helps anyone who looks at the crack later. Take dated photos with a ruler or tape measure held right next to the crack, and repeat them every few weeks from the same spot. If the crack is getting wider or longer, those pictures will show it.
Should You Call a Structural Engineer or a Foundation Repair Company First?
Call an independent structural engineer first, because the engineer diagnoses the problem without selling the repair.
Foundation repair companies are contractors. They install piers, wall anchors, braces, and drainage systems. Their inspection may be tied to a sales proposal for the work they do, so the diagnosis and the price can arrive in the same visit.
An engineer's report gives you a written scope of work. Hand that same scope to several contractors and you can compare bids line by line, since everyone is pricing the same fix. You can also ask whether the engineer is able to review the finished repair against the plan.
Plenty of good repair contractors do honest work. Diagnosis and repair are still two different jobs, and keeping them separate lets you know the fix was chosen for your house and not for a product line.
What Happens During a Structural Engineer Inspection?
A structural engineer visits the property, looks closely at the problem area and the structure around it, and then gives you a written letter or report with findings and next steps.
The visit usually follows these steps:
- You describe the concern and share any home inspection report you have.
- The engineer reviews the foundation and framing on site, starting at the problem area and working outward.
- The engineer takes measurements, such as floor level and how far a wall leans.
- The engineer explains the likely cause and how serious the problem is.
- You receive a written report or sealed letter with recommendations.
That report does several jobs. Buyers and sellers use it to make decisions and negotiate, and lenders may ask for it before closing. Contractors use it to price the repair. Building officials may want it for a permit.
Remodel projects add a design phase. After confirming which walls carry weight, the engineer sizes beams and posts and prepares the drawings the building department needs.
You'll get more out of the visit if you have a few things ready:
- The home inspection report
- Photos of the problem, ideally dated
- When you first noticed the problem
- Records of any past repairs
Do You Need Both When Buying a House?
Most buyers start with a general home inspection, then add a structural engineer only if the inspector flags a structural concern or the house shows clear warning signs.
Both should happen inside your inspection contingency period, the window in your contract when you can ask for repairs or walk away. Book the engineer as soon as the inspection report lands. Those deadlines go fast.
An engineer's report gives you facts to work with. Instead of guessing what a crack might cost, you can ask the seller for a specific repair or a credit based on a written recommendation.
Sellers can use the same tool from the other side. A structural letter prepared before listing can answer buyer questions early, before they turn into a stalled deal.
Older homes and homes with past foundation work are good candidates for both a home inspection and a structural engineer's review.
Structural Concerns Common in Clayton and St. Louis County Homes
In older homes, and wherever clay soils and freeze-thaw winters are present, basement wall and foundation questions can come up, and some homeowners end up needing an engineer. Open Concept Engineering is based in Clayton, MO.
Clay soil swells when it gets wet and shrinks when it dries out. That cycle pushes on basement walls season after season, and over time it can cause bowing or horizontal cracks.
Older homes may have block or stone foundations. Their original framing may not match the loads people put on houses today, such as heavier finishes or a second-floor bath that wasn't part of the first plan.
Open-concept remodels in older homes often mean taking out walls that carry weight. Before you start, check with your local building department about permit rules and whether your project needs sealed drawings.
Office and mixed-use buildings may call for a structural engineer for tenant improvements and acquisitions. A home inspection doesn't cover that work.
Key Takeaways
A general home inspector is the right call for a broad check of the whole house. A structural engineer is the right call when you see a red flag, when your inspection report says "further evaluation," or when you plan to change walls or beams.
If a crack is growing or a wall is starting to bow, we'd rather you call while the fix is still small. Open Concept Engineering is based in Clayton, MO.